ENW 3D Printed Applicator Tool for Tesla AC cleaner Koolit.

3D printed applicator to make it easier to apply Kool-it AC odor remover on Tesla Model 3 and Y vehicle. This item is not associated with Kool-it or Tesla.

• 3D printed applicator to make it easier to apply Kool-it AC odor remover on Tesla Model 3 and Model Y vehicle.
• It is hard to apply the AC odor remover on Tesla Model 3 and Model Y because there is no AC drain tube. Application of the odor remover has to be done through the in cabin AC filter compartment.
• With this tool you can hold the odor remover tube at optimum angle, access down to the bottom of the compartment and prevent the tube from flailing when expelling the foam.
• In addition of using the odor remover, you may need to change the air filter as well.
• This item is not associated with Kool-it or Tesla. This is for applicator tool only doesn't include the odor remover.
• To use: Make sure the hose is firmly attached to the Kool-it cap. Logo facing up, loop the hose throught the middle, wiggle in at the tip of the applicator, reduce the slack by retract the hose a bit through the middle. Then it is ready for use.